串联冰蓄冷系统设计中的泵能耗分析

介绍了串联冰蓄冷系统设计中泵能耗的3种节能方法：串联泵，变频泵和制冷机旁通，通过对某工程实例的模拟计算，对比分析了这3种方式的节能效果，提出了有效的节能方式。     

Variance estimation for the 2006 French housing survey

In the 2006 French housing survey, information is collected on many aspects of housing to describe the housing stock in France and the housing conditions of French households. The basic national sample results from a multistage sampling design. Complementary samples were selected to perform accurate estimations for socio-demographic domains. Some French regions proceeded to a regional and local extension of the national sample. The variance is estimated for a region with a regional and local extension of the basic national sample.     

Sequential estimation problems for negative exponential populations

The literature on sequential estimation problems for negative exponential populations has been reviewed here, We attempt to bring in all the published and unpublished materials known to us in a fairly coherent fashion. Both the concepts and theoretical findings are discussed.     

The effect of non-normality on estimating the variance of the combined ratio estimate in complex surveys

The performance of the balanced half-sample, jackknife and linearization methods for estimating the variance of the combined ratio estimate is studied by means of a computer simulation using artificially generated non-normally distributed populations.

The results of this investigation demonstrate that the variance estimates for the combined ratio estimate may be highly biased and unstable when the underlying distributions are non-normal. This is particularly true when the number of observations available from each stratum is small. The jack-     

输送黏性介质时叶轮出口角对泵性能的影响

为了研究离心泵在输送黏性介质时,叶轮出口角对泵性能的影响,采用FLUENT软件,对2种不同叶轮出口角的 离心泵,分别在清水和5种不同黏性的油性介质下,进行数值模拟分析,预测离心泵在各工况下的水力性能。结果表明： 输送介质为清水时,增大出口角能提高扬程但会降低水力效率;介质运动黏度介于10. 80~ 65. 00 mm2／s时,增加叶轮出 口角能同时提高扬程和效率;介质运动黏度≥65. 00 1111112/S时,增加出口角不能改善其水力性能。文章研究结果能改善 离心泵的水力设计方法,确保泵的高效运行。     

双螺杆泵Ω形对称型螺杆流场数值分析

由于螺杆泵几何结构及流体流动状态较为复杂,其压力分布和速度等特性很难用数学解析法来分析计算。本文利用参数化设计模块建立双螺杆泵Q形对称型螺杆三维模型,构建双螺杆流道的流场分析模型,运用有限元分析方法得出了双螺杆泵流道内压力场和速度场分布规律。结果表明：流体在流道中的流速分布具有规律性,整个流道的流场速度高低交替变化,在螺杆与衬套间隙处的流动为层流,螺旋面接触区内的流动为复杂的湍流,离螺杆啮合区近的螺旋槽内易发生涡流。本研究结果对于了解双螺杆泵螺杆工况下的性能情况具有重要的参考价值。     

Could Removing Arsenic from Tobacco Smoke Significantly Reduce Smoker Risks of Lung Cancer?

If a specific biological mechanism could be determined by which a carcinogen increases lung cancer risk, how might this knowledge be used to improve risk assessment? To explore this issue, we assume (perhaps incorrectly) that arsenic in cigarette smoke increases lung cancer risk by hypermethylating the promoter region of gene p16INK4a, leading to a more rapid entry of altered (initiated) cells into a clonal expansion phase. The potential impact on lung cancer of removing arsenic is then quantified using a three‐stage version of a multistage clonal expansion (MSCE) model. This refines the usual two‐stage clonal expansion (TSCE) model of carcinogenesis by resolving its intermediate or “initiated” cell compartment into two subcompartments, representing experimentally observed “patch” and “field” cells. This refinement allows p16 methylation effects to be represented as speeding transitions of cells from the patch state to the clonally expanding field state. Given these assumptions, removing arsenic might greatly reduce the number of nonsmall cell lung cancer cells (NSCLCs) produced in smokers, by up to two‐thirds, depending on the fraction (between 0 and 1) of the smoking‐induced increase in the patch‐to‐field transition rate prevented if arsenic were removed. At present, this fraction is unknown (and could be as low as zero), but the possibility that it could be high (close to 1) cannot be ruled out without further data.     

水泵叶轮设计中轴面流道及流线的确定

应用偏微分数值网络生成技术，提出了水泵叶轮设计的新方法，该方法可以准确地确定轴面流道和流线，较好地解决了水泵计算机辅助设计中的一个关键问题。     

FL115离心式机油滤清器的特性研究与试验分析

建立了分流离心式滤清器转速特性和液力特性的数学模型.通过试验得到FL115离心式滤清器在不同喷嘴口径以及不同温度工况下的转速特性曲线和液力特性曲线,以及滤清效率.分析了转子转速、驱动流量和进油压力三者之间的关系,推出了设计喷嘴的最佳口径范围.通过理论数据与试验数据的比较,证明了该数学模型可以作为研发离心式滤清器的设计参考.     

Diesel Engine Exhaust and Lung Cancer Mortality: Time‐Related Factors in Exposure and Risk

To develop a quantitative exposure‐response relationship between concentrations and durations of inhaled diesel engine exhaust (DEE) and increases in lung cancer risks, we examined the role of temporal factors in modifying the estimated effects of exposure to DEE on lung cancer mortality and characterized risk by mine type in the Diesel Exhaust in Miners Study (DEMS) cohort, which followed 12,315 workers through December 1997. We analyzed the data using parametric functions based on concepts of multistage carcinogenesis to directly estimate the hazard functions associated with estimated exposure to a surrogate marker of DEE, respirable elemental carbon (REC). The REC‐associated risk of lung cancer mortality in DEMS is driven by increased risk in only one of four mine types (limestone), with statistically significant heterogeneity by mine type and no significant exposure‐response relationship after removal of the limestone mine workers. Temporal factors, such as duration of exposure, play an important role in determining the risk of lung cancer mortality following exposure to REC, and the relative risk declines after exposure to REC stops. There is evidence of effect modification of risk by attained age. The modifying impact of temporal factors and effect modification by age should be addressed in any quantitative risk assessment (QRA) of DEE. Until there is a better understanding of why the risk appears to be confined to a single mine type, data from DEMS cannot reliably be used for QRA.