首页 | 本学科首页   官方微博 | 高级检索  
     检索      

基于提高有载Q的120 MHz低相噪晶体振荡器设计
引用本文:黄显核,王艳,严刚峰.基于提高有载Q的120 MHz低相噪晶体振荡器设计[J].电子科技大学学报(社会科学版),2009(5).
作者姓名:黄显核  王艳  严刚峰
作者单位:电子科技大学空天科学技术研究院;
基金项目:2007年度四川省学术和技术带头人培养基金
摘    要:从反馈振荡器的Leeson模型相位噪声表达式出发,分析了有载Q的重要性,针对基本皮尔斯振荡电路推导出有载Q的表达式,得到C1越大,有载Q越高的结论。在此基础上设计了一个120MHz AT切低相噪晶体振荡器样机,经实际测试,该振荡器在偏离载频100Hz、220Hz、1kHz和底部相位噪声分别达到了-130dBc/Hz、-142dBc/Hz、-155dBc/Hz和小于-175dBc/Hz。结果表明,从提高有载Q出发对低相噪晶体振荡器进行设计是可行的。

关 键 词:晶体振荡器  相位噪声  Leeson模型  有载Q  皮尔斯振荡电路  

Design of 120 MHz Low Phase Noise Crystal Oscillator Based on Improving the Loaded Q
HUANG Xian-he,WANG Yan, YAN Gang-feng.Design of 120 MHz Low Phase Noise Crystal Oscillator Based on Improving the Loaded Q[J].Journal of University of Electronic Science and Technology of China(Social Sciences Edition),2009(5).
Authors:HUANG Xian-he  WANG Yan    YAN Gang-feng
Institution:HUANG Xian-he,WANG Yan,, YAN Gang-feng(Institute of Astronautics & Aeronautics,University of Electronic Science & Technology of China Chengdu 610054)
Abstract:The importance of the loaded Q are analyzed on the basis of phase noise equation of Leeson model in feedback oscillator,the formula of loaded Q is derived by the analysis of Pierce oscillator circuit,and we can draw a conclusion that the larger C1 is,the higher loaded Q becomes.Based on this conclusion,a design of the prototype 120 MHz AT-cut crystal oscillator is presented and the experiments are carried out.The measurement results of phase noise are -130 dBc/Hz@100 Hz,-142 dBc/Hz@220 Hz,-155 dBc/Hz@1 kHz ...
Keywords:crystal oscillators  phase noise  Leeson model  loaded Q  Pierce oscillator circuit  
本文献已被 CNKI 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号