基于最大熵谱估计的机载雷达杂波抑制技术

在讨论机载雷达地面杂波的基础上，利用最大熵估计法对机载雷达杂波进行抑制，并引入了ｃｈｏｌｃｓｋｙ分解快速算法求解最大熵谱的ＡＲ模型参数。计算机模拟表明，基于最大熵谱估计的机载雷达杂波抑制技术有很高的谱分辨率，不仅能跟踪主杂波的频率位置而且能跟踪其谱宽度，因而具有较为满意的杂波对消化与改善因子。     

二元序列优化的二种快速算法

基于二相编码雷达对大压缩比信号的要求,提出了一种比直接算法平均提高效率0.5P(P 为序列长度)的快速数字优化方法。作为这种快速算法的实际应用,还对 P=255的二相编码脉冲压缩信号进行了优化。     

降低线性调频脉冲压缩信号旁瓣的方法

讨论线性调频脉冲压缩信号距离旁瓣的抑制。研究如何降低小时带积线性调频信号距离旁瓣电平问题,针对该信号频谱矩形特性差,提出了采用频谱修正方法来提高脉冲压缩信号的主副比。该方法具有全数字式处理特点,适宜使用IMS A100器件实现脉冲压缩处理。计算机模拟结果表明,无论是小时带积还是大时带积的线性调频信号,经谱修正后,脉冲压缩信号的主副比均舍得到提高。     

Two-dimensional generalisations of dynamic programming for image analysis

Dynamic programming (DP) is a fast, elegant method for solving many one-dimensional optimisation problems but, unfortunately, most problems in image analysis, such as restoration and warping, are two-dimensional. We consider three generalisations of DP. The first is iterated dynamic programming (IDP), where DP is used to recursively solve each of a sequence of one-dimensional problems in turn, to find a local optimum. A second algorithm is an empirical, stochastic optimiser, which is implemented by adding progressively less noise to IDP. The final approach replaces DP by a more computationally intensive Forward-Backward Gibbs Sampler, and uses a simulated annealing cooling schedule. Results are compared with existing pixel-by-pixel methods of iterated conditional modes (ICM) and simulated annealing in two applications: to restore a synthetic aperture radar (SAR) image, and to warp a pulsed-field electrophoresis gel into alignment with a reference image. We find that IDP and its stochastic variant outperform the remaining algorithms.     

Assessment of Airborne Exposure to Trihalomethanes from Tap Water in Residential Showers and Baths

This study evaluates airborne concentrations of common trihalomethane (THM) compounds in bathrooms during showering and bathing in homes supplied with chlorinated tap water. Three homes in an urban area were selected, each having three bedrooms, a full bath, and approximately 1,000 square feet of living area. THMs were concurrently measured in tap water and air in the shower/bath enclosure and the bathroom vanity area using Summa canisters. Chloroform (TCM), bromodichloromethane (BDCM), and chlorodibromomethane (CDBM) were quantified using U.S. Environmental Protection Agency (EPA) Method TO-14. Air samples were collected prior to, during, and after the water-use event for 16 shower and 7 bath events. Flow rate and temperature were measured, but not controlled. The increase in average airborne concentration (+/- standard error) during showers (expressed as microg/m3 in shower enclosure or bathroom air per microg/L in water) was 3.3+/-0.4 for TCM, 1.8+/-0.3 for BDCM, and 0.5+/-0.1 for CDBM (n = 12), and during baths was 1.2+/-0.4 for TCM, 0.59+/-0.21 for BDCM, and 0.15+/-0.05 for CDBM (n = 4). The relative contribution of each chemical to the airborne concentrations was consistent for all shower and bath events, with apparent release of TCM > BDCM > CDBM. The results are therefore consistent with their relative concentration in tap water and their vapor pressures. When the shower findings for TCM are normalized for water concentration, flow rate, shower volume, and duration, the average exposure concentrations in these urban residences are about 30% lower than those reported by other investigators using EPA analytical methods. This difference is likely attributable primarily to greater air exchange rates in residential shower/bath stalls compared to more "airtight" laboratory shower chambers. This appears to be the first field study to thoroughly evaluate THM exposures from residential showers and baths, and can be used to validate previously published models of tap water volatile chemical transfer to indoor air.     

载频解调式脉冲调制器的研制

介绍了一种新型载频解调式栅极脉冲调制器.调制器由2只脉冲变压器、载频调制控制电路、解调与脉冲输出电路组成.调制器采用了内载频脉冲驱动模式,利用了MOSFET的极分布电容对信号的延时作用,通过二极管解调还原调制管触发脉冲,最终输出正负电压的调制脉冲.载频信号频率大于200 kHz,隔离变压器具有尺寸小,绕组匝数少的特点.采用这种模式的调制器,输出脉冲宽度宽、前后沿小、工作比高.详细介绍了基于载频解调式脉冲调制器的应用实例,并对其性能参数进行了测试.     

最优的核判别分析用于雷达目标识别

特征提取是雷达目标识别研究中的重要问题,有效、稳健的特征是提高识别率的关键。核判别分析(KDA)是一种抽取非线性特征的有效方法,但它会因为奇异性问题而难以求解。基于子空间投影的思想,给出一种最优的核判别分析(OKDA)方法,用于对雷达目标的距离像进行特征提取,然后采用基于核的非线性分类器对所提取的特征进行分类,实现对雷达目标的识别。分别对仿真和实测距离像进行实验,结果表明该方法具有较好的识别效果。     

色散特性对毫米波频率步进雷达影响的研究

对影响毫米波频率步进雷达分辨率的主要因素进行了分析。除目标速度以外,为毫米波频率步进雷达提供频率信号的频率源的色散特性也会对雷达分辨率造成恶化影响。微波频段上的色散特性会被搬移到毫米波频段,导致毫米波发射信号和本振信号的初始相位差不为常数,对雷达系统尤其是距离分辨率造成严重影响。仿真结果与实验结果一致。为了抵消色散特性对雷达分辨率的恶化影响,可以通过对色散特性的补偿来实现。色散特性补偿的方法被应用到实现W波段频率步进频率源的设计中,满足了0.45m距离分辨率的要求。     

相控阵雷达低仰角目标DOA估计的算法

在相控阵雷达跟踪低仰角目标时,采用频率捷变技术可以有效地减小雷达回波中直射信号和反射信号的相关性,抑制多径效应对目标到达方向估计造成的影响,提高角度估计的精度和性能。再用修正的AR模型算法,不仅可以在此基础上进一步去掉这两种信号的相关性,而且能正确估计出目标和镜像的仰角。计算机仿真实验结果验证了频率捷变和修正AR模型算法理论的正确性,以及在与其他方法比较的情况下,两者结合在去相关性能上的优越性和工程实用性。     

KS,χ~2检验方法的K分布杂波参数估计研究

提出了一种基于矩估计的KS,χ2检验方法,用于对K分布杂波进行参数估计。该方法从拟合最优的角度进行参数估计,结合矩估计将二维优化转化为一维优化问题。仿真结果表明,该参数估计方法相比于二四阶矩估计方法有明显的改善,KS与分数阶矩法相比,仿真效果较好。χ2法在小v值时与分数阶矩法相当,当v增大时,性能下降。