首页 | 本学科首页   官方微博 | 高级检索  
     

起伏多相流管路持液率计算方法研究
引用本文:喻西崇赵金洲,冯叔初. 起伏多相流管路持液率计算方法研究[J]. 西南石油大学学报(社会科学版), 2017, 22(3): 94-97. DOI: 10.3863/j.issn.1000-2634.2000.03.026
作者姓名:喻西崇赵金洲  冯叔初
作者单位:(1.西南石油学院石油工程学院,四川南充637001; 2.石油大学(华东))
摘    要:起伏多相流管路持液率计算方法在工艺计算中具有重要的地位,但目前只能靠经验或半经验相关式计算。计算水平管持液率,Eaton和DuklerII相关式较好;在下坡管段使用BB相关式,易导致持液率小于0的情况,一般不采用BB相关式计算持液率;在上坡管段,如果对应水平持液率大于0.309 7时,宜采用其它方法计算持液率或者在程序中将持液率大于1时自动赋1处理;计算起伏管路的持液率采用BBE、BBD和MBX相关式误差较小。

关 键 词:起伏   多相管流   持液率   研究
收稿时间:1999-11-18

THE PREDICTION METHOD OF HOLDUP IN UNDULAT-ED MULTIPHASE PIPELINES
Yu Xi-chong Feng Shu-chu Li Yuxin. THE PREDICTION METHOD OF HOLDUP IN UNDULAT-ED MULTIPHASE PIPELINES[J]. Journal of Southwest Petroleum University(Social Sciences Edition), 2017, 22(3): 94-97. DOI: 10.3863/j.issn.1000-2634.2000.03.026
Authors:Yu Xi-chong Feng Shu-chu Li Yuxin
Affiliation:(Southwest Petroleum Inst.)
Abstract:Holdup calculation mainly depends on empirical or semiempirical correlation at present, so the prediction of liquid holdup in undulated multiphase pipelines is very important for technological calculation. Eaton and Dukler II correlation arethe best for calculating liquid holdup in horizontal pipe, In downhill pipe, Beggs&Brills(BB) correlations cannot be adopt-ed because holdup may be less than 0.0. In uphill pipe, if holdup corresponding horizontal pipe is greater than 0.3097,other correlation should be used. BBE, BBD and MBX correla-tions are considered as better correlations at the present.
Keywords:undulation   multiphase pipe flow   holdup   research
点击此处可从《西南石油大学学报(社会科学版)》浏览原始摘要信息
点击此处可从《西南石油大学学报(社会科学版)》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号